About the Dew-Not Dew Remover
 
Introducing Dew-Not's new Dual Channel Controller. The DNC01 controller is a dual channel
controller based on PWM (pulse width modulation) technology. Each
channel controls two outputs for a total of four outputs. Each
channel is capable of a duty cycle from 5% on time (effectively off)
to 95% on time at the high setting. Learn more
...
 Proudly
made in the USA, the Dew-Not Dew Remover is a thick film heater manufactured for operation at 12 volts. Sixty-six percent of the surface area is heat
emitting - this means more even heat distribution and no localized hot spots or burnouts often associated with resistance wire heaters.
Protected by over 30 USA and international patents, and carrying more than 20 years of constant improvements and enhancements, the Dew-Not
Dew Remover is the ultimate in reliability and efficiency.
Dew-Not is available for all popular sized telescopes and custom sizes are available upon request. Each heater comes with a
standard six foot cord and phono-plug connector.*
 Binoview
is the ultimate binoviewer optic dew remover. Using the same technology as our standard Dew-Not dew remover, Binoview helps ensure the
clearest nighttime viewing possible. Includes tandem wraps for Binoviewers-two 6" wraps joined with 4" jumper. One power supply cord. Power takeoff plug for powering heater for objective, Starbeam, etc.
Using Dew-Not Heater and Binoview
Wrap the heater around the tube with red side in, then secure it in place with the Velcro® tab. Plug the phono-connector into the
controller* (sold separately) and follow the manufacturer's instructions.
If you have any questions, please contact
*Compatible with Kendrick controllers and Dew-Buster. |
